Adjustment And Setup Items; Adjustment Item List; Procedure After Replacing The Carriage Unit Or Multi Sensor - Canon iPF605 Service Manual

Chapter 4

4.5 Adjustment and Setup Items

4.5.1 Adjustment Item List

The following adjustment procedures need to be performed when the parts have been replaced or remove and then reinstalled:

4.5.2 Procedure after Replacing the Carriage Unit or Multi Sensor

a) Multi Sensor Recalibration
Since the multi sensor has individual electrical specificity, the following are recalibrated at the factory, namely, the optical axis of the sensor, the sensor gain for
measuring the printhead height and sensor calibration. Accordingly, carry out the following adjustments in the service mode whenever replacing the carriage unit
or multi sensor.
- Service mode : SERVICE MODE > ADJUST > GAP CALIB.
- Service mode : SERVICE MODE > ADJUST > PRINT PATTERN > OPTICAL AXIS
Media type : Photo glossy paper
Media size : Media having a width equal too larger than that of A2-size paper
The multi sensor reference plate(QL2-1561-000:PLATE, REFLECTION, MULTI-SENSOR) must be replaced at the same time whenever the carriage or the multi
sensor is being replaced.
4-56
Adjustment item
Multi sensor recalibration
Adjusting wire roller
Head management sensor recalibration
T-4-1
Adjustment timing
Multi sensor replacement/removal
Carriage unit replacement/removal
Wire guide replacement/removal
Carriage unit replacement/removal
Head management sensor replacement/removal
Carriage unit replacement/removal
0016-9220
0013-4203