12
en | Notices
Switch Setting Sensitivity Alarm Response
8*
9*
* Do not use positions 8 and 9. They are not valid.
2.
Figure 4.3: Sensitivity Switch
2014.01 | 06 | F.01U.068.899
Set the receiver's sensitivity switch to your selected setting. The sensitivity switch is
located to the right of the optical module. The indicator, or pointer marking, runs along
the side of the switches' shaft as indicated in the following figure.
Installation Instructions
Long-range Beam Smoke Detectors
Beam Length
Not used
Not used
Bosch Security Systems, Inc.