Water inlet fault
Problem
The Inlet/Drain indica‐
tor light flashes.
The dishwasher stops
during a programme.
The Inlet/Drain indica‐
tor light flashes.
Fault code or ap‐
pears in the display.
Possible cause and remedy
The tap is turned off.
Turn on the tap fully.
Before rectifying the problem you must:
Switch the dishwasher off with the button.
Water intake is restricted.
Turn on the tap fully and start the programme
again.
Clean the water inlet filter (see "Maintenance").
The water pressure at the intake is lower than 30
kPa (0.3 bar).
Seek professional advice.
Problem solving guide
67