Miele TX2070 Operating Instructions Manual page 12

Warning and Safety instructions

Do not connect the dishwasher to the mains supply until it has
been fully installed and any adjustment has been made to the door
springs.

Do not connect the appliance to the mains electricity supply by a
multi-socket adapter or an extension lead. These do not guarantee
the required safety of the appliance (e.g. danger of overheating).

This appliance must not be installed and operated in mobile in‐
stallations (e.g. on a ship).

Do not install the dishwasher in a room where there is a risk of
frost. Frozen hoses may burst or split. The reliability of the electronic
control unit may be impaired at temperatures below freezing point.

The plastic housing of the water connection contains an electrical
valve. The housing must not be dipped in water.

There are electrical wires in the water inlet hose. Do not cut the
water inlet hose, even if it is too long.

The integrated Waterproof system offers protection from water
damage, provided the following conditions are met:
– The dishwasher is correctly installed and plumbed in.
– The dishwasher is properly maintained and parts are replaced
where it can be seen that this is necessary.
– The tap has been turned off when the appliance is not used for a
longer period of time (e.g. during holidays).
The Waterproof system will work even if the appliance is switched
off. However, the appliance must remain connected to the electricity
supply.

The water pressure (flow pressure at the connection point) must
be between 30 and 1000 kPa (0.3 and 10 bar).

A damaged appliance could be dangerous. If the dishwasher gets
damaged, switch it off at the mains and call Miele.
12