Problem solving guide
Water inlet fault
Problem
One of the following
messages appears in
the display:
Open stopcock
Water intake
76
Cause and remedy
The stopcock is closed.
Open the stopcock fully.
Before rectifying the problem:
Switch the dishwasher off.
The water inlet is restricted.
Open the stopcock fully and start the programme
again.
Clean the filter in the water inlet (see "Cleaning
and care" – Cleaning the filter in the water inlet").
The water-connection pressure is lower than
50 kPa.
Seek professional advice.
The on-site connection for the water drainage may
be too low and you will need to vent the water
drainage (see "Installation – Water drainage").