ATN TTWS Series Operator's Manual page 40

e) When the Reticle has been adjusted to the desired position,
press the Center button. This "SV?" Icon will appear (Figure 3.16).
f) To insure the new Reticle position is saved, continue holding the
Center button down until the "OK" icon appears (Figure 3.17).
g) This position is now the new "Zero".
h) Pressing the Center button now, will continue the rotation through
the menu's as normal.
Temporary adjustments:
Should you want to temporarily make a windage or range adjust-
ment, repeat steps A through E, but, only hold the button down
momentarily (i.e. not long enough for the "OK" to appear).
This will not save the settings, so that when the TTWS is turned off,
the Reticle will return to it's saved position.
3-12
X= 20
Y= 35
SV?
FIGURE 3.16
X= 20
Y= 35
OK
FIGURE 3.17