Detaching/Attaching Stand Base; Detaching Procedure - Eizo FlexScan EV2316W User Manual

6-2. Detaching/Attaching Stand Base

Detaching procedure

The stand base that was attached during setup can be detached using the following procedures.
1.
Lay the LCD monitor on a soft cloth spread over on a stable surface with the
panel surface facing down.
2.
Turn the fixing screw on the stand base to detach it.
Note
• The fixing screw can be removed by hand. If the fixing screw is too tight, use a coin or flathead screwdriver.
3.
Turn the stand base in the counterclockwise direction to detach it.
Note
• Reattach the fixing screw onto the stand base for when the stand base is used again.
47
Chapter6Reference