Detaching/Attaching Stand Base - Eizo FlexScan EV2450-BK User Manual

Attachment procedure
1.
Lay the LCD monitor on a soft cloth spread over a stable and flat surface
with the panel surface facing down.
2.
Remove the stand.
Prepare a screwdriver.
Use the screwdriver to loosen the screws (four) that secure the unit to the stand.
3.
Attach the arm or stand to the monitor.
Secure the monitor to the arm or stand using the screws specified in the User's Manual of the
arm or stand.

6-2. Detaching/Attaching Stand Base

Detachment procedure
The stand base that was attached during setup can be detached using the following procedures.
1.
Lay the LCD monitor on a soft cloth spread over on a stable surface with the panel surface facing down.
2.
Turn the fixing screw on the stand base to detach it.
Note
• The fixing screw can be removed by hand. If the fixing screw is too tight, use a coin or flathead screwdriver.
- 43 -
Chapter 6 Reference