Belkin F1DN104M User Manual page 25

Installation
Table of Contents SECTIONS
Notes about display resolution setting:
- The Belkin Secure Windowing KVM channel resolution, selected from the
channel menu, determines the size of the channel window. It will not
affect the actual resolution projected by the connected PC.
- The Belkin Secure Windowing KVM is capable of scaling the image in two
possible factors: 2x and 4x allowing the user to fit more information on the
same display size.
- Selection of resolution higher or lower than resolution range of
connected display may result image loss! In this case you can change
display to different type or restore factory defaults.
- To restore factory default settings – use a paper clip or another sharp
object and press momentarily the recessed RFD switch located at the rear
side above the DC power jack.
- See table in page 14 for supported output resolutions per model.
Once completed to set the required settings, the administrator key should
be rotated back to the locked position and key must be removed to enable
normal product operation.
After Installation Checklist
Once completed to set requires settings – check the final device product
configuration with all connected computers operating:
1. Check that each window is connected to the proper PC and have
the required border color.
2. Check that each window is coupled to the proper keyboard and
mouse (no cables are crossed between channels).
3. Check that each window is coupled to the proper CAC input (if
applicable).
Belkin® Secure 4 port Windowing KVM Switch User Manual
1 2 3 4
4. Check that each window is coupled to the proper audio output (if
applicable).
5. Check that all video cable thumb screws are secured.
6. Check that administrator key was removed from the device.
Channel #1 Input resolution setting window
25
5 6
Single Display installation
(104M)
In the Dual
installation (204M) the two
grayed out buttons in the
picture on the left, will be
functional
7
Display