Table of Contents
Advertisement
Installation
Table of Contents
Step 3 Power up
•
Power up user display. Select through display setup menu DVI input if
applicable.
•
Power up the Belkin Secure Windowing KVM by connecting the DC
power plug. Power up will take up to 30 sec.
•
Power up the connected computers.
Note: When you power on your computers, the Belkin Secure Windowing
KVM emulates both a mouse and keyboard on each port and allows your
computers to boot normally. The computer connected to port "1" will be
displayed on the user's display. Check to see that the keyboard, display,
and mouse are working normally. Repeat this check with all occupied ports
to verify that all computers are connected and responding correctly.
If you encounter an error, check your cable connections for that computer
and reboot. If the problem persists, please refer to the Troubleshooting
section in this User Manual.
Notice: If during installation as a result of bad output resolution
(resolution not supported by display) the video image on the user
display is lost it is possible to recover the device through the use of
Restore Factory Defaults switch (see item 17 in page 12). Pressing this
switch momentarily will return the Belkin Secure Windowing KVM to
the original production settings including lowest output resolution.
For information on how to reset the device to factory defaults see the
Troubleshooting section of this manual.
Belkin® Secure 4 port Windowing KVM Switch User Manual
SECTIONS
1
2
3
The following process can be performed before or after power up.
•
If computer and Belkin Secure Windowing KVM supports user
authentication device, connect another USB cable for the CAC
function. CAC USB cable can be connected to any free USB port in the
computer.
21
4
5
6
7
Advertisement
Table of Contents
