Belkin F1DN104M User Manual page 22

Color Code Chip Installation
The Belkin Secure Windowing KVM port-selector buttons can be color-
coded for easier identification. Refer to the installation instructions below.
Note: You may have to remove the existing black color chip first.
Port Name Label
The included network-name labels can be placed in the area underneath
the port-selector buttons for port identification. Blank labels are also
provided.
Belkin® Secure 4 port Windowing KVM Switch User Manual
Common Access Card (CAC) Configuration and Operation
CAC connection to the computer requires a separate USB cable connection
and allows the user to specify whether there is a CAC required for that
computer or not. This allows the CAC to be connected and controlled
separately to the keyboard, mouse, video and audio.
Step 1 Installation
1.1 Using the included USB cable, connect one end of the cable to the
computer that requires CAC, and the other end to the CAC port on the
KVM Switch that corresponds to the computer.
1.2 Enable CAC for the same port connection in Step 1.1 by switching the
CAC switch to the right.
1.3 Repeat steps above for additional computers that require CAC.
Note: Make sure that the CAC switch is disabled (left) for all other
non-connected CAC systems.
Once configured, the CAC connection will be switched only when required
by the connected computer. When switching from a CAC enabled port to a
non-CAC enabled port, the CAC connection will remain with the last
previously selected port where the CAC was set to enable.
22