Table of Contents
Advertisement
Programming (Cont.)
White Balance
TOUR Notes
Master Dimmer
Red, Green & Blue &
White Color Selection
Color Macros
Strobe
ID Address Selection
Auto
Dimmer Speed
December 11, 2009
This setting allows the user to select the white color shown by the COLORado™ 2 Tour
when the DMX controller's Red, Green and Blue faders are set to "255".
1) Press <MENU> repeatedly until CAL2 shows, and press <ENTER> to accept.
2) Press <MENU> again at RGBW.
3) Use <UP> or <DOWN> to select a color (Red, Green or Blue).
4) Use <UP> or <DOWN> to select a color value (0~255).
5) Repeat for the other colors.
6) Press <MENU> to exit once done.
These notes intent to clarify the way the TOUR DMX personality works.
· Channel 1 controls the intensity of the currently projected color.
· When the slider is at the highest position (255) the intensity of the output is at its
maximum
· Channels, 2, 3, 4 and 5 control the intensity ratio of each of the Red, Green, Blue
and White LEDs
· When the slider is at the highest position (255) the intensity of each color is at its
maximum
· You can combine channels, 2, 3, 4 and 5 to create over 16 million colors
· Channel 6 selects the required Color Macro
· Channel 6 has priority over channels 2, 3, 4 and 5
· Channel 1 controls the intensity of the Color Macro
· Channel 7 controls the strobe of channels 1~6
· Strobe 1 is with RGB in-step
· Strobe 2 is with RGB out-step
· Strobe 3 is a pulse strobe(fast on/slow off)
· Strobe 4 is a pulse strobe (slow on/fast off)
· Channel 7 has priority over channels 2, 3, 4 and 5
· Channel 9 selects the target ID address
· Each independent DMX address may have up to 66 independent ID addresses
· An ID address of 0 will activate all ID address locations
· Channel 8 selects the preset Auto programs AT. 01~10 or the custom Auto
programs CUS. 01~10
· When activating the custom Auto programs CUS. 01~10, it is possible to control the
Step Time and Fade Time using channels 2 and 3 respectively
· Channel 8 has priority over channels 2, 3, 4, 5, 6 & 7
· Channel 10 is for selecting the dimmer mode and speed. When Dimmer is set to
Off, RGBW and Master Dimmer are linear. Otherwise, Dim1 is the fastest dimmer
curve, while Dim4 is the slowest.
-13-
Operation
COLORado™ 2 Tour User Manual Rev. 01e
Advertisement
Table of Contents
