Sherwood RD-7500 Operating Instructions Manual page 24

Adjust the level of the selected channel
2
as desired.
ADJUST
or
Repeat the above steps 1 and 2 to adjust each channel level.
3
Memorizing the adjusted channel levels
This unit gives two spaces("REF.1" and "REF.2") for memory of the adjusted channel levels. You can call the
memorized again whenever you want.
After doing the above steps 1~3 in "Adjusting the current channel level" procedure, press the
1
(MEMO/)ENTER button.
MEMO/ENTER
or
Select the desired memory between REF. 1
2
and REF. 2.
ADJUST
LEVEL
or
VOL.
LEVEL
LEVEL LEVEL
+, -
VOL.
ENTER
1 2 3 4 5
6 7 8 9 0
VOL.
LEVEL
LEVEL
+, -
VOL.
24
• The LFE level can be adjusted within the range of
-10~0 dB and other channel levels within the range
of -15~+15 dB.
• In general, we recommend the LFE level to be
adjusted to 0 dB.(However, the recommended LFE
level for some early DTS software is -10 dB.) If the
recommended levels seem too high, lower the setting
as necessary.
• If the channel display disappears, start from the step
1 again.
• "REF. 1" is displayed and "1" flickers.
Press (MEMO/)ENTER button.
3
MEMO/ENTER
or
1 2
6 7
• The adjusted channel levels have now been
memorized.
ENTER
3 4 5
8 9 0