Adjusting Each Channel Level With Test Tone - Sherwood RD-7500 Operating Instructions Manual

Adjusting each channel level with test tone

• The volume level of each channel can be adjusted easily with the test tone function.
Note : When the 7 CH DIRECT is selected as an input source, the SPEAKER button is set to off or it is in the stereo
mode, the test tone function does not work.
Enter the test tone mode.
1
B
VOL.
LEVEL
VOL.
At each channel, adjust the level as desired
2
until the sound level of each speaker is heard
to be equally loud.
ADJUST
or
• You can select the desired channel and adjust its level with
repeating the steps 1 and 2 in "Adjusting each channel
level" procedure.
Adjusting the current channel level
• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources
or to suit your tastes.
Press the CHANNEL SELECTOR(CH SEL.) button.
1
CHANNEL
SELECTOR
or or
• You can adjust the LFE level for Dolby Digital or DTS program source that includes LFE signal.
• When it is in the stereo or Dolby Virtual mode or the speaker setting is "N", center, surround L/R, surround back
or subwoofer channel will not be selected.
• When the SPEAKER button is set to off, only the front L/R channel can be selected.
T.TONE
LEVEL
VOL.
LEVEL
LEVEL LEVEL
+, -
VOL.
VOL.
CH.SEL
LEVEL LEVEL
VOL.
23
• The test tone will be heard from the speaker of each
channel for 2 seconds as follows:
FL C FR
Front Left Center Front Right
SW
Subwoofer
• When the speaker setting is "N", the test tone of the
corresponding channel is not available.
Cancel the test tone function.
3
B
VOL.
LEVEL
VOL.
• "REF. 1"(or "USER", etc.) is displayed and each time
this button is pressed, the corresponding channel is
selected and displayed for several seconds as follows:
FL C
( DTS L DD L )
DTS LFE Dolby Digital LFE
( ) : impossible when the analog input is selected as signal input.
SR SB SL
Surround Surround Surround
Right Back Left
T.TONE
LEVEL
FR SR SB
SW SL