Table of Contents
Advertisement
FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE
MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE
INSTRUCTION MANUAL.
ASSEMBLY TOOLS REQUIRED
*
6mm Allen Wrench
*
4mm Allen Wrench
*
3mm Allen Wrench
*
2.5mm Allen Wrench
ASSEMBLY TIME ESTIMATE - 2-3 hours
STAND
1. Assemble stand as shown in Fig. 5 using parts
shown in Fig. 4. The parts for the stand (as shown in Fig.
4) are:
5. Two Top End Braces for Stand (11-3/4")
6. Two Top Side Braces for Stand (15-3/4")
7. Two Lower Side Braces for Stand (20-1/2")
8. Two Lower End Braces for Stand (16-1/2")
9. Four Legs for Stand
10. Four Feet for Stand Legs
To assemble, insert the 5/16-18x3/4" carriage head bolts
through legs and braces then place the 5/16" flat
washers on the bolts and secure with the 5/16-18 hex
nuts. Only tighten nuts finger-tight at this time.
IMPORTANT: The top lips of two upper end braces (5)
Fig. 5, must fit on top of the top lips of two upper side
braces (6).
2. Assemble four rubber feet (10), to the bottom of each
leg (9) as shown.
DUST CHUTE TO STAND
1. The front of the stand is indicated by switch opening
(B) Fig. 6, making the outfeed end of the stand (C) and
the infeed end (A).
2. Assemble dust chute (E) Fig. 6, to outfeed end of
stand (C) as shown. Align the four holes (D) Fig. 6, in the
dust chute with the four holes in the stand. Insert a 5/16-
18x3/4" carriage bolt through the hole in the dust chute
and stand. Place a 5/16" flat washer onto the screw and
thread a 5/16-18 hex nut onto the screw. Repeat this
process for the three remaining holes in the dust chute
and stand. Only tighten hex nuts fingertight at this
time.
ASSEMBLY
*
12x14mm Open End Wrench
*
8x10mm Open End Wrench
(All are supplied.)
5
D
E
10
6
7
6
8
9
10
Fig. 5
C
D
B
Fig. 6
5
8
7
D
A
Hide quick links:
Advertisement
Table of Contents
