Initial Set Mode Items - Icom ic-U80 Instruction Manual

■ Initial Set mode items

D Key-touch beep
Sets the key-touch beep to level 1 to 3 or OFF.
• When changing the beep level, beeps sound at the level.
D Time-out timer
To prevent accidental prolonged transmission, the trans-
ceiver has a time-out timer. This function cuts transmission
OFF after 1 to 30 minutes of continuous transmission.
To turn OFF the function, select "tot.OF."
• tot.OF : Turns OFF the function.
• tot. 1 to 30 : If continuous transmission exceeds the selected pe-
riod, the transmission will be cut off.
Approximately 10 seconds before the Time-out timer is ac-
tivated, the transceiver emits a beep tone as a warning.
Be careful! When using the BP-263 battery case, the bat-
teries will become hot if this Time-out timer function is
turned OFF or set to a long time period, and transmission
is made for long periods.
D Auto power-OFF
The transceiver can be set to beep and automatically turn
OFF, when no key operation occurs during a specified period.
(default: bEP. 2)
• POF.OF
• POF.30/1H/2H : The transceiver is automatically turned OFF when
NOTE: The setting is maintained even after the transceiver
is turned OFF by the Auto Power-OFF function. To cancel
the function, select "POF.OF."
(default: tot. 5)
D Lockout
Sets the lockout type to repeater, busy or OFF.
• RLO.OF : Turns OFF the function (default).
• RLO.RP : The Repeater Lockout function inhibits transmitting
• RLO.bU
SET MODES
: Turns OFF the function. (default)
no operation occurs during the selected period.
when the channel is busy, except while receiving a sig-
nal that includes a matched tone.
: The Busy Lockout function inhibits transmitting while
receiving a signal.
10
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
45