Lexicon MPX 200 User Manual page 46

Program Descriptions
* PRESET 117
This preset supplies reverb while preserving stereo imaging
in a live stage setup. Stereo imaging is preserved via time
delay rather than conventional L/R panning so that a
proper channel mix is maintained in both L and R speak-
ers. To use this program, observe the following:
• Use the MPX 200 in-line between mixer and house
amps, not as an effect that is mixed back into the
main L and R signals.
• On your mixer, pan the input channel for each
musician fully to that musician's side of the stage.
• Keep Mix set to 50% (the default setting when
Program Load is set to Program).
• Adjust your Reverb level by changing the
Balance parameter between full left (-50) and
about -10. (Typical values should be between -45
and -40.)
4-16
• Set "Width" for the distance between the speakers
at each side of the stage. The program loads with
an assumed width of approximately 20 ft. The
available range via the Adjust knob is 10-50 ft.
These values assume that most audience mem-
bers are seated within 30 degrees to either side of
the stage centerline. If many audience members
are seated further to the sides of the stage the
Adjust setting can be increased, but otherwise it
should be kept as low as possible.
Lexicon, Inc.