Lexicon MPX 200 User Manual page 29

MPX 200
Note:
Program Compressor Mode is not activated until
you load a new program after selecting Program.
9. Patching: Allows you to temporarily suspend (Off)
and restore (On) any Learned MIDI patches.
10. MIDI Channel: Allows selection of a MIDI channel
for all MPX 200 messages (Learned and Program
Changes). The choices are Off, Channels 1
through 16, or All Channels (OMNI mode).
11. MIDI Program Change: Determines whether or
not the MPX 200 will recognize MIDI Program
Change messages for loading programs.
12. MIDI Clock Receive: Determines whether or not
the MPX 200 will recognize MIDI Clock messages.
13. MIDI OUT/THRU: Sets the rear panel MIDI OUT/THRU
jack for either MIDI OUT or MIDI THRU functionality.
Note:
MIDI dumps can only be performed when this
parameter is set to MIDI OUT. ( See items 15-17)
14. AutoLoad: Determines whether the selected pro-
gram loads automatically. If AutoLoad is set to
On, a new program selected with the Adjust knob
will be loaded automatically about 1/4-second
after the knob has stopped turning.
Note:
When any of the dumps are received by the MPX
200 from an external device, they are automati-
cally applied or stored.
System Mode
continued on next page . . .
3-5