Lexicon MPX 200 User Manual page 27

MPX 200
10. MIDI Channel Off, Channels 1 -16,
All (Omni)
11. MIDI Pgm Off or On*
Change
12. MIDI Clock Off or On*
Receive
13. MIDI Out* or Thru
OUT/THRU
14. Autoload Off* or On
15. Dump
User Bank Press Store to execute
16. Dump Current
Program Press Store to execute
17. Dump
System Press Store to execute
18. Clear
User Bank Press Store to execute
19. Initialize
* designates default value
1. Output Level: This is the first parameter that you
will see when entering the System Mode. It adjusts
the overall output level of the MPX 200 from 0dB
(maximum) down to Off.
2. Input Source: Here you select either the Analog or
Digital (S/PDIF) input. If you select Digital In and
no digital signal is present, the MPX 200 will mute.
Note:
When the Input Source is set to Digital and the
MPX 200 is in either Load mode or Edit mode, the
display will show a message for four seconds
whenever it detects any change in the S/PDIF
input status. For example, if you remove the cable
while it is connected and receiving a valid 44.1k
S/PDIF signal, the display will show "nod"
for "no digital". Whenever it re-acquires
a digital signal, it will show "dig".
System Mode
continued on next page . . .
3-3