Vertex Standard VX-230 Series Service Manual page 18

Alignment
9. DCS D <W
EVIATION
This parameter is to align DCS Deviation of the selected channel.
1. Click the "DCS Deviation (W)" or "DCS Deviation (N)"
button to open the DCS Deviation Alignment window.
2. Input the desired DCS Code to the "DCS Code" Box.
Available input range is 000 to 777 (Octal notation), and
default value is 523.
3. Click the "PTT" button on the desired frequency which you
wish to alignment. The radio starts to transmit on selected
frequency.
4. Set the value to get desired deviation (Wide: 0.65 kHz, Nar-
row: 0.4 kHz) on the deviation meter by the following ways:
 Drag the slide bar
 Click the up/down button
 Press the left/right arrow key of the computer's keyboard
 Enter the value in the "Data" box from the computer's
keyboard.
5. After getting the desired deviation, click the "PTT" button
to stop the transmit.
6. Click the "OK" button to finish the DCS Deviation align-
ment and save the data.
You may select the alignment type from the Radio button (ADJ
Type) located at the bottom of the screen, as needed..
ADJ Type
Single : Alignment value change only to selected channel.
All Freq : Alignment value change for connecting with other
channels.
10. B
ATTERY
This parameter is to align the "Alert Reference voltage" and "Write Protect Level" voltage. When the DC source power becomes
below the "Write Protect Level" voltage, the radio will stop writing data to the EEPROM due to prevent the erroneous writing.
1. Click the "Battery" button to open the Battery Alignment
window.
2. Reduce the DC Power source to 6.5 V (according to the
indication), then click the"Start" button. The alignment value
will show in the "New" box.
3. Reduce the DC Power source to 5.5 V (according to the
indication), then click the "Start" button. The alignment value
will show in the "New" box.
4. Set the DC Power source to 7.5 V (according to the indica-
tion), then click the "Start" button. The alignment value will
show in the "New" box.
VX-230 Series UHF FM Transceiver Service Manual
> / <N >
IDE ARROW
18