Setting Up The Printer - Lexmark T620 Setup Manual

Handhold
Tab
Round peg

Setting up the printer

Square hole
In order to ensure adequate clearance when
installing system board options, see "Install mem-
ory and option cards" on page 17 before you posi-
tion the printer if:
• You plan to install memory or option
• You will have less than 605.6 mm (24 in.)
CAUTION!
1
Ask someone to help you lift the printer by
the handholds and lower it onto the duplex
unit, optional drawer, table or printer cabinet.
The tab, round peg, and square holes on top
of any drawer or the duplex unit help you
seat the printer so the edges are aligned
properly. Make sure the printer is securely in
place.
2
Remove the print cartridge packaging.
a
b
Print cartridge
cards
and
clearance on the left side of the printer.
Make sure your fingers are not under
the printer when you set it down.
Push the release latch and open the
printer upper front door.
Grasp the print cartridge by the hand grip
and pull the print cartridge up and out.
7