Table of Contents
Advertisement
Note
For a more specific location
name, press Option # for
compass directions (north,
northeast, east, southeast,
south, southwest, west,
northwest).
Note
If you wish to use a sensor
number other than the next
one available, use the num-
bered keys to enter a 2 digit
sensor number immediately
after entering the sensor
type.
15
Version 3
*
Press for program
information.
Unit #
Instruction
Summary
Add Option
Option #1: Panel Beeps
Option #2:
Panel Voice
Option #3:
Latchkey Time
Option #36:
Sensor Activated Light Lockout Start Time
Option #37:
Sensor Activated Light Lockout Stop Time
Option #41:
Chime Voice
Option #42:
Speaker Volume
Option #43:
Pager Phone Number
Option #55:
Status Beep Volume
Add
Option #
Press
and follow voice prompts.
See Note
¾
To add a hardwire or RF sensor or remote control:
1. Press Add. The panel announces "Select from Main Menu."
2. Press Sensor/Remote. The panel announces "Press button on sensor."
3. Press the sensor program button or release sensor tamper switch. The panel announces
"Keychain Remote. Press sensor again for next name or press Done to select."
4. Press Sensor/Remote repeatedly until you hear the name or item you want to use. An
alphabetical list of names the panel uses appears in Appendix B. Each name may be used
more than once.
5. Press DONE when you hear the desired name. The panel announces "Use numbered keys
to enter sensor group."
6. Enter the 2-digit sensor group. The panel announces the first available sensor number and
sensor group, then prompts you to press DONE to accept.
7. Press DONE. The panel confirms programming by announcing the sensor number, name,
and group.
¾
To delete sensors:
1. Press Delete. The panel announces "Select from Main Menu."
2. Press Sensor/Remote repeatedly until you hear the name and number you want deleted,
then press DONE. The panel announces that the sensor is deleted.
X-10 Module Operation
Use the following procedure to program X-10 module operations into panel memory. Notice
that the Light Control button is used to program all X-10 module operations (light, appliance,
and universal).
¾
To program the house code:
1. Press Add.
2. Press Light Control repeatedly until you hear the desired house code letter.
3. Press DONE.
4. Set the HOUSE dial on each lamp, appliance, and universal module, to the same letter.
5. Set the HOUSE dial on powerhorn/remote sirens to the next sequential alphabetical letter.
¾
To add an entry/exit activated module:
1. Press A
.
DD
2. Press Light Control.
START MENU
Add
Delete
Cancel
Test
MAIN MENU
Light
Sensor/
Access
Control
Option #
Remote
Code
*
*
*
0
1
2
CONTROL MENU
Entry/Exit
Delay
Sensors
Time
-
*
*
*
4
5
6
7
-
Minutes
+
DONE
Add Access Code
Add
Access Code
DONE
Press
See Note
use red numbers to enter 4-digit code.
Set Clock
Clock Set
Hours
Minutes
Press
See Note
System should be checked
by a qualified technician
at least every three years.
Clock
Set
3
Note:
Hold key or press
Hours
+
repeatedly until you
hear the desired item.
8
9
Delete
To delete an option or access code
Delete
press
and follow the voice
prompting.
Cancel
If you make a mistake or want to
, then
Cancel
start over press
Sensor or Phone Test
Test
DONE
To select a test, press
and
follow the voice prompting.
Euro Simon Security System
Advertisement
Table of Contents
