Registering Door/Window Sensors - GE JSC1300 Owner's Manual

Installation
Initializing Keyfob Remotes
Press and hold the ARM button on the Keyfob remote for 3-4 seconds
and then release it. This initializes the remote and picks a random
code that is used when it is registered with the Console.
Registering the Keyfob Remote with the Console
Press either of the Menu up/down buttons (under the lid to the bottom left of the display).
The display then shows ENTER PIN (Personal Identification Number) in the top line.
ENTER PIN
12:00 am
The default PIN is 0000, so press 0000 on the keypad (under the lid to the bottom left of
the display), or enter your PIN if you changed it (see page 24). This clears the top line
and shows * for each number entered.
****
12:00 am
This takes you to the first level of the menu at step 1. This is the INSTALLATION level.
When you see INSTALL on the display, press OK. The display then looks like this:
INSTALL
ZONE
Now simply press any button on the Keyfob remote. The Console acknowledges that it
has been registered by beeping and displaying RMOT 1 SET.
Repeat this for any other Keyfob Remotes you want to register. The display increments to
RMOT 2 SET, etc. as you register more remotes.
Press Clear repeatedly to back out of the menu. You are asked to confirm, 1. YES, 2 NO.
Pressing 1 takes you back to the HOME CONTROL screen.
Press 2 to stay in the INSTALL menu.
12
Installation
Initializing Door/Window Sensors
Pry the two halves of the Door/Window Sensor apart and install
2 AAA alkaline batteries inside. Observe polarity.
Set switch to MAX (left) for doors, or MIN (right) for windows.
Press and hold the button inside the Sensor for 3-4 seconds
and then release it. This initializes the Sensor and picks a
random code that is used when it is registered with the Console.
Replace cover and place the magnet next to the Sensor (with
the arrows aligned).
See pages 14 and 15 if you want to use an additional magnetic contact switch.
Registering Door/Window Sensors with the Console
Press either of the Menu up/down buttons (under the lid to the bottom left of the display).
The display then shows ENTER PIN (Personal Identification Number) in the top line.
ENTER PIN
12:00 am
The default PIN is 0000, see page 24 for how you can change this, but for now press
0000 on the keypad (under the lid to the bottom left of the display). This clears the top line
and shows * for each number entered.
****
12:00 am
This takes you to the first level of the menu at step 1. This is the INSTALLATION level.
When you see INSTALL on the display, press OK. The display then looks like this:
INSTALL
ZONE
13