Dynamic Addressing Process - Avaya 4601 Installation Manual

Dynamic Addressing Process

Note:
For IP telephones supporting the H.323 protocol, before starting this process you
Note:
must have an extension number for the IP telephone and the Avaya
Communication Manager security code (password) for that extension. An
exception is when unnamed registration is enabled, which requires neither an
extension nor password entry. For more information, see
For IP telephones supporting the SIP protocol, before starting this process you
must have an OPTIM extension number for the SIP telephone, the Avaya
Communication Manager security code (password), and a login and password on
the SES server.
The following description of the process of installing the IP telephones assumes that the
process is executed successfully. Only an initial out of the box installation is described. For
errors that might be encountered during the process and the messages displayed, see
Chapter 4: Troubleshooting
Note:
Dynamic addressing is the only way to establish addressing parameters on the
Note:
4601 IP Telephone. Because the 4601 lacks a display, this telephone uses its
LEDs to provide status indication. The instructions indicate processing
exceptions or elaborations specifically for 4601 IP Telephones where applicable.
When you plug the IP telephone set into the Ethernet wall jack and apply power, if applicable,
the following process takes place.
Note:
If the application has already been downloaded, the whole process takes
Note:
approximately 1 to 2 minutes after the telephone is plugged in. For an initial
installation, including the application download, the process might take 5 - 10
minutes. The duration is based on LAN loading, how many telephones are being
installed at once, and similar factors.
Do not unplug the power cord during the download process.
1. The telephone activates the Ethernet line interface, the PC Ethernet jack, and dial pad input
to allow the invocation of procedures. The activation occurs as soon as possible after
power-up or a reset.
The telephone detects and displays the speed of the Ethernet interface in Mbps, that is, 10
or 100. The message No Ethernet displays until the software determines whether the
interface is 10 Mbps or 100 Mbps.
Guidelines.
Dynamic Addressing Process
Unnamed Registration.
Issue 3 April 2006 29