BRP Evinrude E15D Operator's Manual page 56

Product Information
Displacement
Engine Type
Full Throttle Operating
Range
(1)
Power
Idle RPM in Neutral
(2)
Ignition Timing
Emission Control System:
(2)
per SAE J1930
Fuel Requirements
Oil – Lubricant
Warning Signals
(3)(4)
Battery, Minimum
(2)
Spark Plug
Fuses
Fuel Filter
Battery Charging
Gearcase – Lubricant
– Capacity
Power Trim/Tilt – Fluid
– Capacity
Propeller
Weight
Sound at Driver's Ear
(LpA) ICOMIA 39.94
Transom Height
54
150, 175, 200 Models
158.2 cu. in. (2592 cc)
60° V, 6 Cylinder, Two-Cycle, E-TEC
150 HP – 4850 to 5850 RPM
175 HP – 4850 to 5850 RPM
200 HP – 4850 to 5850 RPM
150 HP – 150 HP (110 kw) @ 5350 RPM
175 HP – 175 HP (129 kw) @ 5350 RPM
200 HP – 200 HP (147 kw) @ 5350 RPM
(2)
500 ± 50
Controlled by the outboard's EMM
ECM, E-TEC (Engine Control Module, E-TEC)
(2)
87 Pump Posted AKI (90 RON) – Refer to Minimum Octane
on page 18
Evinrude/Johnson XD100 oil or TC-W3 NMMA-certified oil
– Refer to Oil Requirements on page 16
Controlled by the outboard's EMM
675 CCA (845 MCA) 12 volt or
800 CCA (1000 MCA) 12 volt below 32°F (0°C)
Refer to ECI Label
P/N 967545 – Refer to Fuse on page 31
P/N 502906
50-Amp, Fully Regulated, Dual Isolated
(5)
Evinrude/Johnson HPF XR Gearcase Lubricant
DPL, DSL Models (O) – 33.1 fl. oz. (980 ml)
DHL, HSL Models (L2) – 32.5 fl. oz. (960 ml)
DPX, DBX, DMX Models (M2) – 38.9 fl. oz. (1150 ml)
DCX Models (M2-CR) – 35.8 fl. oz. (1060 ml)
Evinrude/Johnson Power Trim/Tilt and Power Steering Fluid
21 fl. oz. (622 ml)
Refer to Propeller Selection on page 49
L Models – 418 lbs. (190 kg)
X Models – 433 lbs. (196 kg)
79.0 dB(A)
L Models – 19 1/2 to 20 in. (495 to 508 mm)
X Models – 24 1/2 to 25 in. (622 to 635 mm)