Table of Contents
Advertisement
TV system selection by country
This is a multi-standard television which can be used in most European countries. For either automatic or manual
tuning you need to tell the television which television system to use by choosing the appropriate country, for
example 'GB' stands for 'Great Britain'. Changing the country in the 'system' line has immediate effect on the sig-
nal the television is receiving, so if the country does not match the signal then either there will be no sound, no
colour or the picture will be distorted. When you store the broadcast channel to a program number the television
remembers the country for that channel.
Highlight the 'system' line with the PR buttons.
Tuning by broadcast channel number
• If you know the broadcast channel number used by the station or piece of equipment you want to tune in, you
can enter it by pressing the number buttons while the green highlight is on this line. Highlight the 'channel' line
with the PR buttons.
• Briefly pressing one of the volume buttons (
• Pressing and holding one of the volume buttons (
finds the next signal, then stop tuning. The television will only find a signal that uses a standard broadcast
channel. Use 'Frequency' for tuning in older equipment.
• We've included a map of transmitters and broadcast channels in Great Britain at the end of this
booklet.
Fine tuning
You can tune by broadcast channel number and find there is a signal on some channel but it is not properly tuned in.
Change to tuning by frequency and fine tune by repeatedly pressing the left or right volume button (
pressing the volume button repeatedly on the side which improves the picture or sound until it is best, then go to
Program storage number' below.
Tuning by frequency
• Move the green highlight to the 'freq' line with the PR buttons. If you know the frequency used by the
station or piece of equipment you want to tune in, enter the first three digits by pressing the number buttons
while the green highlight is on this line. Change the digits after the decimal point by pressing the left volume
button (
) to decrease or the right volume button (
• If you don't know the frequency, press and hold one of the volume buttons () for a few seconds to make the
television search until it finds the next signal, then stop tuning. Give the signal a programme number by
following 'Program storage number' below.
Channel name
1. Highlight the 'name' line with the PR button
2. Press the right hand volume button (
the first character position in the name.
3. Change the character by pressing the PR buttons.
4. Repeat 2 and 3 to for each character position. If you need a space you will find it in the
character set.
5. After the last character position the green highlight moves back to 'name'. Store the name to
the programme number by pressing the OK button.
Program storage number
When you have tuned in a new station or some other equipment, use this line to give a programme number to it.
Highlight the 'store to' line by pressing one of the PR buttons.
Change the country with the volume
PR
buttons (
PR
) changes the channel number one at a time.
) for a few seconds makes the television search until it
) to increase them.
PR
PR
) to put the green highlight on
PR
PR
11
).
PR
B
PR
PR
PR
PR
PR
). Keep
NORMAL/OK
PR
PR
Advertisement
Table of Contents
