Chapter 9: Scanner Setup; Installing The Printer Operator Panel Cover - Lexmark T64x Setup Manual

9
Scanner setup

Installing the printer operator panel cover

If you purchased your printer and MFP option separately, you will need to install the printer operator panel cover. If you
purchased a printer and MFP together, the printer operator panel cover is installed; go to Unlocking the scanner on
page 43.
1
Locate the cover bracket packaged with your MFP.
2
Remove the backing from the tape on the rear of the cover bracket.
3
Align the holes in the cover bracket with the buttons on the operator panel, and then press it into place.
4
Align the cover with the cover bracket.
5
Press and hold the four corners against the bracket and slide the cover down until it snaps into place.
Scanner setup
42