4413-XXX
Carrier assembly with belt removal
1. Remove the top cover assembly. See
removal" on page
2. Remove print engine. See
page
4-16.
3. Depress the belt tensioner (A) until tension is released.
4. Remove the belt (B) from the carrier motor.
5. Remove two carrier shaft retainer springs (C) that secure the
shaft.
6. Disconnect carrier cables from the system board.
7. Remove the carrier shaft.
8. Remove the carrier assembly.
Note: Position of encoder strip.
4-18
Service Manual
4-5.
"Print engine removal" on
"Top cover assembly