Table of Contents
Advertisement
A. LISTINGS AND CODE APPROVALS
This fireplace system has been tested and listed in
accordance with UL127 and ULC-S610-M87 standards,
and has been listed by OMNI Test Laboratories, Inc., for
installation and operation in the United States and Canada
as described in this manual. The Constitution Fireplace is
approved for mobile home installations when not installed in
a sleeping room and when an outside combustion air inlet
is provided. The structural integrity of the mobile home floor,
ceiling, and walls must be maintained. The fireplace must be
properly grounded to the frame of the mobile home. Outside
Air must be installed in a mobile home installation.
This fireplace has been tested and listed for use with the
SL-300 Series chimney and fireplace components listed
on page 7.
Check with your local building code agency before you begin
your installation to ensure compliance with local codes,
including the need for permits and follow-up inspections. Be
sure local building codes do not supersede UL specifications
and always obtain a building permit so that insurance
protection benefits cannot be unexpectedly cancelled.
If you need assistance during installation, please contact
your local dealer. For the number of your nearest Heatilator
dealer, please call 1-800-843-2848.
Heatilator® is a registered trademark of Hearth & Home
Technologies, Division of HON INDUSTRIES.
WARNING!
This fireplace and its components are designed to be
installed and operated as a system. Any alteration to
or substitution for items in this system, unless allowed
by these installation instructions, will void the OMNI
Test Laboratories, Inc., listing and may void the product
warranty. It may also create a hazardous installation. Read
through these instructions thoroughly before starting
your installation and follow them carefully throughout
your project.
4-03
EPA Certified Fireplace
B. DESCRIPTION OF THE FIREPLACE
1. The fireplace system consists of the following:
a. Fireplace
b. Firebrick
c. Chimney Termination Cap
d. Chimney System
e. Hearth Extension
f.
Outside Air
2. Required Components Include:
a. Chimney Air Kit
3. Optional Components Include:
a. Fire Screen
b. Lintel Bar
c. Heat Zone Kit
NOTE: Illustrations used throughout these instructions
reflect "typical installations" and are for design purposes
only. Actual installation may vary slightly due to individual
design preferences. However, minimum clearances must
be maintained at all times.
The illustrations and diagrams used throughout these
installation instructions are not drawn to scale.
Firebrick
Figure 3A - Typical Fireplace System
3
Constitution
SYSTEM
Chimney
Termination Cap
Chimney System
Chimney Air Kit
Fireplace
Outside
Air Kit
Hearth Extension
480-1091
Hide quick links:
Advertisement
Table of Contents
