LevelOne FCS-1060 User Manual page 7

Camera will try WLAN. During the searching and connecting process to the wireless access point
or station, the red LED of the Network Camera will flash every second. Until the Network Camera
connects to the other wireless device, the red LED will become lighted. Operating in either
network mode, the green LED will flash every second as heartbeat to indicate alive. If the red LED
is blinking, please check the network connections.
To install in Ethernet
Make sure the Ethernet is firmly connected to a switch hub. After attaching the Ethernet cable plug
in the power adapter. If the LED turns out to be steady blue, go to next paragraph "Software
installation". If the Ethernet is not available, Network Camera will switch to wireless LAN mode.
To install in wireless LAN (WCS-2060 Only)
If the Ethernet is not available while power on, the Network Camera will search for any access
point with the SSID "default". Once any access point is found, the LED will turn blue to wait for
installation. If the network environment cannot meet the default settings, install Network Camera
in Ethernet to proceed with wireless LAN configuration.
7