Installation; Hardware Installation - LevelOne FCS-1060 User Manual

Installation

In this manual, "User" refers to whoever has access to the Network Camera, and "Administrator"
refers to the person who can configure the Network Camera and grant user access to the camera.

Hardware installation

Connect the power adapter jack to the Network
Camera before plugging in to the power socket. This will
reduce the risk of accidental electric shock.
Please verify that your product package contains all the accessories listed in the foregoing Package Contents.
Depending on the user's application, an Ethernet cable may be needed.
The Ethernet cable should meet the specs of UTP Category 5 and not exceed 100 meters in length.
Upon powering up, the front red LED will become lighted first and then the device will go through
booting process. During the booting process, red, blue and green LEDs will be on. After booted,
the Network Camera will standby for getting IP address. After getting IP Address, the green LED
will blink every second.
The Network Camera will first detect Ethernet. If it does not connect to Ethernet, the Network
6