Tuner Unit (Tux-Dsp04); How To Install The Knob (Vol) (Sv) Assy - Sony MEX-XB100BT Service Manual

MEX-XB100BT
3-9.

TUNER UNIT (TUX-DSP04)

3-10. HOW TO INSTALL THE KNOB (VOL) (SV) ASSY

Note 1: When the knob (VOL) (SV) assy is replaced, Bluetooth informa-
tion writing is necessary. Refer to"BLUETOOTH INFORMA-
TION WRITING METHOD" on page 9.
3 Confirm a top and bottom
direction of NFC logo.
30
3 tuner unit
(TUX-DSP04)
2 Remove the solder.
knob (VOL) (SV) assy
front panel assy
1 Remove the solder.
1 Make sure that the cushion (knob) is installed
correctly.
OK cushion
(knob)
knob
(VOL)
2 Align two shafts and two grooves.
Since the position of the groove to rotate, check
the position of the groove when attach the shaft.
two shafts
two grooves
4 Push until the clicking sound is heard.
Note 2: When pushed by a strong force there is a risk
of damage to the inside of the switch.
Push in the appropriate force, be careful not
to push too strongly.
J001
wire
tuner unit
(TUX-DSP04)
MAIN board
cushion
NG
(knob)
knob
(VOL)