Troubleshooting - Bionaire BCH9440-CN Instruction Leaflet

Trouble
• Remote Does ☛ Battery low.
not work. ☛ Distance too far.
☛ Control Panel Display dirty.
• Heater is ☛ When the heater is in Thermostat
Blowing Cold
Air.
☛ Unit is in the Fan Only setting.
☛ Power Button may have been
• Fan Speed ☛ Max and Heat & $ave
Doesn't
Change.
• Unexpected ☛ You may hear a popping or
Noise.
• Unexpected ☛ There may be an odor or vapor
Smell.
If you have any questions regarding your product or would like to learn more about other Bionaire
contact our Consumer Service Department at 1-800-253-2764 or visit our website at www.bionairecanada.com. For
inquiries regarding recycling and proper disposal of this product, please contact your local waste management facility.
© 2014 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights reserved. Imported and
distributed by Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions, 20B Hereford
Street, Brampton, Ontario L6Y 0M1.
174943
T R O U B L E S H O O T I N G
Troubleshooting for your Heater
Probable Cause
Mode and reaches the set
temperature it will automatically
perform a 15 second cool down
(blowing cold air) to ensure
thermostat accuracy.
pressed to turn off the heater.
settings
®
control the heat output of the heater
and not the fan speed. Fan runs at
the same speed on all settings.
crackling sound as the heater heats
up. This is normal and safe
operation. Once the heater heats
up, the crackling sound will go
away.
coming from the heater the first
time you use it or after prolonged
or seasonal storage.
BCH9440-CN_14EFM1
Solution
✔ Change battery (Disc type, 3 volt, CR2025).
✔ Remote works up to 20 feet (6m).
✔ Be sure to point remote at control panel on heater
and there are no obstructions.
✔ Make sure display panel is clean.
✔ Raise the temperature higher or change setting to
Heat & $ave or Max.
®
✔ Press the Max or Heat & $ave
✔ Press the Power Button to turn on the heater.
✔ Run heater in Max for maximum heat output.
✔ If the noise persists call Bionaire at
1-800-253-2764.
✔ This is normal and is the result of dust or other
debris accumulating on the heating element.
Make sure the heater is in a well ventilated area
and continue running until the odor or vapor goes
away.
Buttons.
®
products, please
®
Printed In China