Power On/Off; Mode Selection; Frost Protect Setting; Thermostat Control - Bionaire BCH9440-CN Instruction Leaflet

F E AT U R E S - O P E R AT I O N S
• Remove the battery from the equipment when it is
not being used for an extended period of time.
• Remove the used battery promptly.
• Do not discard used batteries into household trash
containers. Contact your local government for
disposal or recycling practices in your area.
This Class B digital apparatus complies with Canadian
ICES-003.

OPERATING INSTRUCTIONS

1. Place heater on a firm, level surface.
2. Plug heater into a standard outlet. Once plugged in,
the Power Light will illuminate.
NOTE: Avoid overloading your circuit by not using
other high wattage appliances in the same outlet. At
1500 watts, this unit draws 12.5 Amps.
3. Operate heater by pressing the Power Button ( )
and selecting modes and settings according to
preference.
NOTE: Remove the plastic film from the control
panel before using (if included).

Power On/Off

Press the Power On/Off Button to turn the heater on.
Once on, the heater will run in the Max Heat mode and
the Stay On icon will appear on the LCD Display. Press
the Power On/Off button to manually turn off the heater
at any setting.
NOTE: The Power Light will remain illuminated while unit
is plugged in.

Mode Selection

Select your desired heat settings by pressing the
corresponding buttons as located on your heater or press
the Mode button on remote control to cycle through the
heat settings. An indicator light will illuminate next to
each button to indicate that the selected setting/mode is
activated.
Fan Only Setting
Press the Fan Only Button to run the heater without
heat output. The Stay On icon will appear on the LCD
Display.
– HIGH Heat Setting
Press the Max Button to run the heater continuously at
1500W. The Stay On icon will appear on the LCD
Display.
Heat & $ave
Press the Heat & $ave
efficient Heat & $ave
®
between high (at 1500W) and low (at 750W) heat
settings to provide heat. The Stay On icon will appear
on the LCD Display.

Thermostat Control

Your heater is equipped with a digital thermostat that
allows you to set your heater to a precise comfort level
by turning the Dial Wheel on the control panel or
pressing the arrow buttons on the remote control:
NOTE: If your heater comes with a Thermostat Button
( ) on the control panel or remote control, you may
either press the button or turn the Dial Wheel to activate.
The Thermostat icon ( ) will appear on the LCD
Display.
To preset a precise comfort level, turn the Dial Wheel to
adjust the temperature from 30°C to 18°C (Default:
"30"). The LCD Display will show the selected
temperature reading. When the preset temperature is
reached, the heater will shut off and cool down for 15
seconds. When the room temperature drops below the
preset temperature, the heater will automatically turn on
again to maintain the preset temperature level.
FrostProtect™ Setting
Your heater is equipped with a FrostProtect™ setting.
The heater will turn on automatically when the room
temperature drops below 5°C. To activate FrostProtect™
setting, turn the Dial Wheel to show "5" and the
FrostProtect™ icon ( ) will appear on the LCD
Display.
Setting
®
Button to activate the energy
®
Mode. The heater will now cycle