Oscillation/Timer; Cleaning & Maintenance - Bionaire BCH9440-CN Instruction Leaflet

F E AT U R E S - O P E R AT I O N S
C L E A N I N G / M A I N T E N A N C E
NOTE: It is normal for the heater to cycle on and off to
maintain the preset temperature. Raise the thermostat
setting or operate in Stay On mode to prevent the
heater from cycling. When the preset temperature is
reached or when the heater is shut off, the fan will run
for 15 seconds without heat. This cool down process
ensures an accurate and consistent temperature reading.
NOTE: To shut the heater off at any setting, press the
Power Button ( ) until the LCD Display goes off. The
heater will cool down for 15 seconds, and the Fan Only
indicator light will blink in Amber until cool down is
completed. The digital thermostat has memory; it will
remember the last temperature setting before the heater
is turned off. However, if the heater is unplugged, the
digital thermostat will no longer remember the previous
temperature setting. You will need to reset the digital
thermostat if the heater is unplugged.
Oscillation
Press the Oscillation Button (
remote control to activate or stop the oscillation feature.
NOTE: Please do not manually turn the heater on the
base. It is designed to turn only by motorized oscillation.
Timer
This heater is equipped with 24-Hour Auto Shut-off Timer
feature. This allows you to program your heater to shut
off automatically after running a defined time interval
(from 0 to 24 hours).
1. Press the Timer Button ( ) once. The indicator light
will begin to blink for 5 seconds. The LCD Display will
show "0" and the "Hr" icon.
2. Turn the Dial Wheel on the control panel to adjust
from 0 to 24 to select your desired time interval for
the heater to shut-off automatically. The selected
hour will appear on the LCD Display, and then the
Timer indicator light will stop blinking in 3 seconds to
indicate that the selected timer is activated. The LCD
Display will return to show the preset temperature
and mode setting.
3. To cancel the Timer feature, press the Timer Button
( ) twice within 5 seconds, the Timer indicator light
will go off.
NOTE: The timer does not work with the FrostProtect
Setting.
) on control panel or
®
CLEANING/MAINTENANCE
Always unplug the heater before cleaning and allow the
heater to cool down.
1. Clean the unit with a soft cloth moistened with a mild
soap and water solution.
2. NEVER use abrasive or flammable solvents to clean
the unit.
3. After cleaning, be sure to completely dry the unit
with a cloth or towel.
4. Store heater in a cool, dry location.
5. It is recommended that you store the unit in its
original carton.
TIP: Over time, dust may accumulate on the front
grills. This can be removed by wiping the unit with a
damp cloth.