Table of Contents
Advertisement
F E AT U R E S - O P E R AT I O N S
WARNING: Do not operate the product until fully
assembled; do not operate without the casters attached.
1. Before using the heater make sure that it is on a flat
and stable surface. Damage may occur if it is placed on
an incline or decline.
WARNING: Operate the product in an upright position only.
2. Set all the power switch to OFF position, and plug the
Power Cord into a standard 120-volt AC electrical outlet.
3. Press the Power Switch Button ("I" in Parts description)
first, and then press the Power Button (
the LCD will display the power of medium, temperature
is 25 °C by default, timer does not display.
To shut off the heater, press the power button (
until all LCD lights are off. The power light will remain light
while unit is plugged in and power switch is on.
WARNING: Always unplug the product from the electrical
outlet when it will be left unattended or when it is not in use.
4. To set the required function, proceed as follows:
POWER SETTING:
Press the mode button in succession until the power icon on
the LCD flashes. Use ( ) and (
desired power setting. This unit has 4 power settings, low
(600 Watts), medium (900 Watts), high(1500 Watts), ECO.
ECO mode: on the LCD screen display EC, The heater will now
cycle between high and medium power to provide heat.
) once, and
) again
) button to set your
TEMPERATURE SETTING:
Press the mode button in succession until the temperature
icon on the LCD flashes. Use ( ) and (
your desired room temperature.
The degrees Celsius temperature setting range: 5-35 ° C,
degrees Fahrenheit: 41-95 ° F.
Keep the ( ) or (
) button pressed to move through the
temperatures quickly.
To change from Celsius degrees to Fahrenheit degrees: Press
( ) and ( ) buttons 5 seconds at the same time – the
initial display is in Celsius degrees; after the heater is turned
off, its last setting will be kept in memory (heaters with
memory function only).
TIMER SETTING:
Press the mode button in succession until the timer icon on
LCD flashes. Use ( ) and (
time. The timer setting has a range from 1 to 24 hours. Keep
the ( ) or (
) button pressed to set timer quickly. The
timer pilot light will illuminate when the timer is activated.
To cancel the timer setting, push the ( ) and ( ) button
until the LCD appears "00", the timer pilot light will be fade
out.
) button to set
) button to set your desired
Advertisement
Table of Contents
