Welcome; Tr-069 Protocol Support; Pre-Staging Sip Phones - Mitel 6863i Configuration Manual

Mitel 6800i Series SIP Phones Release 4.0.0 SP1 TR-069 Configuration Guide

WELCOME

This document provides information about Technical Report (TR)-069 protocol support for the
6800i Series (6863i, 6865i, 6867i, and 6869i) SIP IP Phones.

TR-069 PROTOCOL SUPPORT

The IP Phones support the TR-069 protocol. This protocol is a bi-directional HTTP-based
protocol that provides a means of communication between Customer-Premises Equipment
(CPE) (e.g. IP phones) and Auto Configuration Servers (ACSs) over DSL/broadband
connections. It includes both safe auto configuration and the control of other CPE management
functions within an integrated framework.
Note: Implementation of the TR-069 protocol follows TR-104 and TR-106 standards to
the extent of data sets applicable to SIP IP phones.
Service providers can, through TR-069, use one common platform to manage (through the
internet) all of their customer premise devices, regardless of the device or manufacturer. If
TR-069 is enabled on the phones, when the remote ACS boots the phones, they contact the
ACS and establish the configuration automatically.
In addition to configuring the phone with TR-069, you can also do the following:
• Reboot the phone
• Reset to factory defaults
• Update the firmware of the device
• Backup/restore configuration
• Upload the log file
An Administrator can configure the TR-069 parameters using the configuration files only. For
more information about the TR-069 parameters, see
page 3.

PRE-STAGING SIP PHONES

There are two options available to enable TR-069 support for the phones:
a. An Administrator can provide a configuration file (that can be taken from the TFTP site
or during RCS provisioning) with parameters that are specified in
Descriptions"
b. The phones can be branded and the branded default configuration file can contain all
the necessary parameters.
After phones (with correct firmware) receive this configuration file, they will start a bootstrap
procedure and connect to the ACS server.
1
on page 3.
"TR-069 Parameter Descriptions"
"TR-069 Parameter
on