7.15
Removal Of The FC Evaporator Cover
Fan cover Removal Tool (T models only)
The following illustration shows a tool that can be made in your workshop. This tool can be used to release
and remove the freezer compartment fan cover in the Active Smart "T" model refrigerators. If preferred, the
tool can be made from a screwdriver with a shaft length of approximately 200mm (7 to 8 inches) long and 4.5
mm (¼ inch) diameter.
B models are removed by grasping the bottom of the evaporator cover and pulling up and forward.
Diagram 7.15
39