Installing Countertop Dispenser With Legs Accessory - Follett Symphony 12 Series Installation, Operation And Service Manual

Fig. 2 – Bottom exiting utilities
(countertop units)
3/4" FPT drain
3/8" OD push-in
water inlet
Installing countertop dispensers
with legs accessory
Do NOT tilt unit farther than 30˚ off
!
vertical plane.
Countertop dispensers that sit on
legs (not bolted to counter) can be
inadvertently moved. Care should be
taken when operating and cleaning to
avoid accidents.
1. Carefully tip dispenser back to expose underside
and block up in place.
2. Screw legs (shipped taped to drain pan of
dispenser) into dispenser bottom, taking care to
seat legs securely against underside of dispenser.
3. Attach bottom panel and hardware to bottom of
dispenser with supplied screws (Fig. 4).
4. Position unit in desired location and adjust bullets
on legs to level in both directions.
5. Make fi nal connections.
Move pipe plug
to back of unit
Remove poly tubing and
fi tting for water inlet
Fig. 3 – Rear exiting utilities
(countertop units)
11.7" (298 mm)
(206 mm)
.9" (23 mm)
1.5"
(39 mm)
Fig. 4 – bottom panel assembly
6
16" (407 mm)
8.1"
3/8" FPT water inlet
3/4" FPT drain
power cord
bottom
panel
screw
leg