Electrolux EDW 1003 Service Manual page 33

6.13. Customer function / deactivation of signal sound
General information
The function deactivation of the signal sound at the cycle end
does not exist generally and must be programmed in the
software variant.
w The deactivation resp. activation of the signal sound is
executed in all designs resp. key arrangements analogously.
w For that you always have to use keys S0, S1, S2 and S3
independent of their variant-depending program load.
w Key S3 is ALWAYS the "signal sound deactivation key"
w The signal sound is always set active by the manufacturer.
w If the signal sound is deactivated, it means that in
general no acoustic end signal will sound any more.
Even the acoustic fault signals cannot be heard any more!
EDW 1003 / VGA
LD1 LD2 LD3
S2 S3
Calling / changing / saving the signal sound deactivation
1. LD1 LD2
S1 S2
LD1 LD2
2.
blinken
LD1 LD2
3.
S2
4.
5.
ENDE
6.
S0
LD1 LD2 LD3 LD4
... AUS nach 60sek. automatisch
... AUS durch manuelle Betätigung über Ein/Aus
LD3 LD4 LD5 LD6
LD7 LD10
LD8 LD11
LD9 LD12
S3 S4 S5 S6
S0
LD3 LD4 LD5 LD6
S0
LD3
S3
blinkt
LD3
ENDE
S3
blinkt
LD3
ENDE
S3
blinkt
LD3
ENDE
S3
LD5 LD6
S0
S0
33
When calling the customer function a washing cycle
must not be selected generally!
Calling the function "signal sound deactivation"
1. Appliance in switched-off condition
2.
Switch on appliance with ON/OFF key S0 -- "prestart" mode
Ä All LEDs of program and option keys are lit.
3. Press keys S2 and S3 simultaneously until the
confirmation LEDs LD1, LD2 and LD3 are flashing.
4. By actuating the function key S3 you now can call the
function. The confirmation LED LD3 continues
flashing, LEDs LD1 and LD2 go out.
The current condition whether the signal sound is
active or not is signalled by the "END" LED.
"END" LED on = signal sound on
"END" LED off = signal sound off
Deactivation resp. activation of the signal sound
5. / 6. By any further actuation of the function key S3 you
activate resp. deactivate the signal sound alternating.
Leaving the function
After pressing the function key S1 last you can leave the
special program as follows.
After 60 seconds all LEDs of program and option keys
are lit automatically.
Now the appliance is again in the "prestart" mode
or
the appliance is switched off by ON/OFF key S0.
Saving the set condition
The currently valid condition is saved directly after
any entry.