Electrolux EDW 1003 Service Manual page 24

6.5. Input philosophy: program sequence
A special feature with the fully integrated appliances is the condition that there are no control and display elements visible when the door has been closed.
That is why important information for the customer, such as the cycle end or information on faults is indicated acoustically in addition..
This result in a few differences for the start, run and end of a cycle in comparison with normal upright, substructure resp. integrated variants of appliances.
l
Cycle start
w
The cycle starts finally only when the door has been closed!
w
After the door has been closed and the cycle has started successfully it is no more possible to make any alterations etc.
But to make changes in the program setting in exceptional cases, you have to open the door during the running cycle.
F interrupt resp.delete cycle
(see description page B 6 / Delete cycle")
F change resp. alter cycle
(see description page B 7.2 / "Reselect cycle")
l
Cycle run
As already described above there are no displays visible with VGA appliances caused
by the type of construction. The optical displays are selected but hidden by the worktop.
w
The LEDs of the selected washing cycle are lit during the whole cycle run.
w
There are no displays which indicate the cycle state.
l
Cycle end
As already described above there are no displays visible with VGA appliances caused
by the type of construction. The optical displays are selected but hidden by the worktop.
w
When the cycle has ended, an acoustic signal will sound.
The acoustic "end" signal is a whistling sound with the following interval:
15 seconds on - 3 minutes off - 15 seconds on - 3 minutes off - 15 seconds on - completely off
The "end" signal is cleared immediately by opening the door.
w
The confirmation LED of the program key of the run-down cycle and the "END" LED are lit,
but are cleared immediately by opening the door.
w
When the cycle end has been reached, it is possible to delete the run-down cycle by
opening and closing the door. After closing the door, the appliance is automatically
again in the "prestart" mode, i.e. a new program could be selected again at once.
w
In order to switch off the appliance completely you have to actuate the ON/OFF key S0.
Even in this case, the run-down cycle is deleted. All displays go out.
24