Operating Instructions; For Your Safety Read Before Lighting - Vermont Castings NBST27 Installation Instructions Manual

NBST27 Unvented Gas Log Set

OPERATING INSTRUCTIONS

Avoid any drafts that alter burner flame patterns. Do not allow fans to blow directly into the fireplace.
Do not place a blower inside the burn area of the firebox. Ceiling fans may create drafts that alter flame
patterns. Sooting and improper burning will result.
During manufacturing, fabricating and shipping, various components of this appliance are treated with
certain oils, films or bonding agents. These chemicals are not harmful, but may produce annoying
smoke and smells as they are burned off during the initial operation of the appliance, possibly causing
headaches or eye or lung irritation. this is a normal and temporary occurrence.
The initial break-in operation should last four hours with the burner at the highest setting. Provide maxi-
mum ventilation by opening windows or doors to allow odors to dissipate. Any odors remaining after
this initial break-in will be slight and will disappear with continued use.
This appliance must not be used with glass doors in the closed position. This can lead to pilot outages
and severe sooting outside the fireplace.
If you do not follow these instruction
exactly, a fire or explosion may result
causing property damage, personal injury
or loss of life.
A. This appliance is equipped with a piezo ignition device which lights the pilot. If piezo is not working properly
see Match lighting Instructions, Page 22.
B. BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
•
Do not attempt to light any appliance.
•
Do not touch any electric switch; do not use
any phone in your building.
•
Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
•
If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in, or turn the gas control
knob. Never use tools. If the knob will not push in
or turn by hand, don't try to repair it. Call a qualified
service technician. Force or attempted repair may
result in a fire or explosion.
D. Do not use this appliance if any part of it has been
under water. Immediately call a qualified service
technician to inspect the appliance and to replace
any part of the control system and any gas control
that has been under water.
20
FOR YOUR SAFETY, READ BEFORE LIGHTING
Control Knobs
Figure 31 -
Burner Controls
OPERATING INSTRUCTIONS
Piezo Ignitor
FP2373
burner controls
FP2373
81D3032