Hri4E Optional Log Set Installation - Regency LRI4E Owners & Installation Manual

Read the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced. Broken
logs can interfere with pilot operation.
Improper positioning of the logs may create carbon build-up and can alter the unit's performance which is not covered under warranty.
*For Touch Ups: Satin Black paint is included for burner, and Dark Brown Paint is included for log set,
Note: This Log installation is for NG units only.
1 Rear Centre Log
2 Centre Right Front Angled Log Piece
3 Right Forked Upright Log
4 Left Angled Upright Log
5 Left Angled Cross Log
6 Right Front Angled Log Piece
7 Centre Left Front Angled Log Piece
Rear Log Bracket (HRI6E/HRI4E units)
Pilot shield (HRI4E units only)
Lava Rock and Embers
Glass quantities with Log installation
HRI4E
HRI6E
Note: If glass previously installed - remove 2lbs to equal above quantity.
Ensure unit is cooled to room temperature and remove glass door.
1. HRI4E Unit only.
Remove burner (see manual for instructions).
Remove existing pilot shield by removing 2 screws.
Install pilot shield provided with Log Set using 2 screws from
previous pilot shield. Reinstall burner.
New Pilot Shield - HRI4E Only
2. Both HRI4E & HRI6E Units.
Sweep glass aside (if already installed) to install Rear Log Bracket,
clip the front edge of the rear bracket on to rear of the burner as
shown below.
Rear Log Bracket
919-350a

HRI4E OPTIONAL LOG SET INSTALLATION

OPTIONAL LOG SET INSTALLATION
5 lbs
6 lbs
5
4
3. Place Log 1 on Rear Log Bracket, ensure Log is centered. Place
small amount of glass crystals on pilot cover, over top pilot area in
front of Log 1.
Center Log 1 on bracket
4. Place Log 2 on the glass, angled with the non charred point of the
Log is approximately 9-1/4" from the right side of the burner tray.
1
HRI6E / HRI4E
installation
1
3
7
2
1
1
2
2
9-1/4"
Position Log 2
LRI4E / HRI4E Direct Vent Gas Insert
|
23
6
| 23
07/30/14