Variable Speed Switch Installation; Mantle Clearances - Napoleon GDS 50 - N Installation And Operation Instruction Manual

INSERT MODEL GDI50 ONLY
FIGURE 41
VARIABLE SPEED SWITCH INSTALLA-
TION
To mount the variable speed switch: from the rear, insert
the rheostat stem through the 3/8" diameter hole in the left
side flashing. From the front, secure with the pal nut and
add the knob. Push the on/off switch into the square open-
ing. Attach wiring as shown.
FLASHING INSTALLA FLASHING INST FLASHING INST FLASHING INST FLASHING INST
equipped with a flashing kit to finish off the fireplace open-
ing. Assemble the flashings using the four #8 x 3/8" screws
and nuts. Prior to installing the flashing kit, open the side
doors, and lift the door off its hinges. Mount the flashing to
the two pieces of angle steel secured to the units' outer
shell using the four #6 x 7/16" screws. These angles are
adjustable. Ensure that the flashing is tight to the extreme
back end of the outer top and vertically plumb.
Remove the paper backing from the tape located on the
back of the logo. Push the logo plugs into the two holes
located at the bottom left corner of the flashing to secure
the logo.
Rehang the side doors. FIGURE 41.
ALLA ALLA ALLATION ALLA TION TION TION TION
The insert is
MANTLE CLEARANCE
to the mantle depth. FIGURE 42. Use the graph to help
evaluate the clearance needed.
M H
A E
I
N
G
T
L H
E T
MANTLE WIDTH
17
FIGURE 42
This can vary according
WS-415-098 / 04.11.00