Stove Vent Connection; Mobile Home Installation - Napoleon GDS 50 - N Installation And Operation Instruction Manual

STOVE VENT CONNECTION

1. Attach the ad-
justable pipe to
the last section of
rigid piping. Se-
cure with screws
2" OVERLAP
and seal.
2. Install the 4"
aluminum flexible
liner to the stove.
Secure with 3
screws and flat
washers. Seal the
VARIABLE
joint and screw
SPEED SWITCH
holes using the
high temperature
sealant provided.
3. Run a bead of
high temperature
sealant around
the inside of the
air intake collar.
Pull the adjust-
able pipe a mini-
mum 2" into the
air intake collar.
Ensure that the sealant is not visible on the exte-
rior pipes once installation is completed. An op-
tional decorative brass band is available for this
use. (Standard with a GD175 kit). In the event that
the venting must be disassembled, care must be
taken to reseal the venting.
Continue with "Gas Installation" Page 15
FIGURE 21
#8x1/2"
SELF DRILLING
SCREWS
HI-TEMP
SEALANT
ON/OFF
SWITCH

MOBILE HOME INSTALLATION

In Canada, mobile home installation may be vented hori-
zontally or vertically. In the United States, it may only be
installed vertically. See "Vertical Venting" or "Horizontal Air
Terminal Installation" for installation.
The fireplace is equipped with two 5/16" diameter holes
located near each
corner of the
base. For mo-
bile home in-
s t a l l a t i o n s ,
the fireplace
must be fas-
tened in
place. Use
#10 screws,
FIGURE 22
i n s e r t e d
through the holes in the base to secure. It is recommended
that the fireplace be secured in all installations.
11
WS-415-098 / 04.11.00