STOVE VENT CONNECTION
1. Attach the ad-
justable pipe to
the last section of
rigid piping. Se-
cure with screws
2" OVERLAP
and seal.
2. Install the 4"
aluminum flexible
liner to the stove.
Secure
with
3
screws and flat
washers. Seal the
VARIABLE
SPEED SWITCH
joint and screw
holes using Mill
Pac high tem-
perature sealant
not supplied.
3. Run a bead of
red RTV high tem-
perature sealant
around the inside
of the air intake
collar. Pull the adjustable pipe a minimum 2" into the air
intake collar.
Ensure that the sealant is not visible on the exte-
rior pipes once installation is completed. An op-
tional decorative brass band is available for this
use. (Standard with a GD175 kit). In the event that
the venting must be disassembled, care must be
taken to reseal the venting.
Continue with "Gas Installation" Page 14
FIGURE 21
#8x1/2"
SELF DRILLING
SCREWS
HI-TEMP
SEALANT
ON/OFF
SWITCH
MOBILE HOME INSTALLATION
In Canada, mobile home installation may be vented hori-
zontally or vertically. In the United States, it may only be
installed vertically. See "Vertical Venting" or "Horizontal Air
Terminal Installation" for installation.
The fireplace is equipped with two 5/16" diameter holes
located near each corner of the base. For mobile home
installations, the fireplace must be fastened in place. Use
#10 screws, inserted through the holes in the base to se-
cure. It is recommended that the fireplace be secured in all
installations.
11
W415-0098 / C / 04.19.06