10. APPROVED FUEL: This appliance is designed specifically for
use only with pelletized wood fuels only. This appliance is
designed and approved for the burning of wood residue pellets
with up to 3% ash content. This appliance is NOT approved to
burn cardboard, nut hulls, cherry pits, corn, etc. regardless
if it is in pellet form. Failure to comply with this restriction
will void all warranties and the safety listing of the fireplace
insert. Consult with your Lennox Hearth Products dealer for
more information on approved pellet fuels.
11. These appliances are designed as supplemental heaters.
Therefore, it is advisable to have an alternate heat source
when installed in a dwelling.
1. CONTINUOUS OPERATION: When operated correctly, this
appliance cannot be overfired. Continuous operation at a
maximum burn can, however, shorten the life of the electri-
cal components (blowers, motors, and electronic controls),
and is not recommended. Typical approved operation would
include running at the low to mid range setting with occasional
running on the maximum setting during the coldest periods
of the winter. DO NOT OVER-FIRE THIS INSERT. Follow all
instructions regarding the proper use of this insert.
13. CAUTION: NEVER PUT FINGERS NEAR AUGER. Pellet fuel is
fed to the UltraGrate™ by a screw auger. This auger is driven
by a high torque motor. The auger is capable of doing seri-
ous harm to fingers. Keep pellets in the hopper at all times
and keep fingers away from auger. The auger can start and
stop automatically at any time while the insert is running.
14.CAUTION: NEVER PUT FINGERS NEAR AUGER. Pellet fuel is
fed to the UltraGrate™ by a screw auger. This auger is driven
by a high torque motor. The auger is capable of doing serious
harm to fingers. Keep pellets in the hopper at all times and
keep fingers away from auger. The auger can start and stop
automatically at any time while the insert is running.
15. FLY ASH BUILD-UP: For all wood pellet fuel-burning heaters,
the combustion gases will contain small particles of fly-ash.
This will vary due to the ash content of the fuel being burned.
Over time, the fly-ash will collect in the exhaust venting
system and restrict the flow of the flue gases. The exhaust
venting system should be inspected regularly and cleaned
as necessary.
16. SOOT FORMATION: Incomplete combustion, such as occurs
during startup, shutdown, or incorrect operation of the room
heater will lead to some soot formation which will collect in
the exhaust venting system. A precautionary inspection on
a regular basis is advisable to determine the necessity of
cleaning. The exhaust venting system should be inspected
regularly and cleaned as necessary.
17. DISPOSING OF ASHES: Any ashes removed from the pellet
fireplace insert must be deposited in a metal container with
a tight-fitting lid. The closed container of ashes should be
placed on a noncombustible floor or on the ground, well
away from all combustible materials, outside of the dwell-
ing pending final disposal. If the ashes are disposed of by
burial in soil or otherwise locally dispersed, they should be
retained in the closed container until all cinders have been
thoroughly cooled.
19. The instructions must be strictly adhered to. Do not use
makeshift methods or compromise in the installation.
0. Do not abuse the door glass by striking, slamming or similar
trauma. Do not operate the insert with the glass removed,
cracked or broken.
18. SAVE THESE INSTRUCTIONS.
19. See the listing label on the appliance.