LevelOne FCS-1070 User Manual page 7

To install in wireless LAN (WCS-2070 only)
If the Ethernet is not available while power on, the Network Camera will search for any access
point with the SSID "default". Once any access point is found, the LED will turn green to wait for
installation. If the network environment cannot meet the default settings, install Network Camera
in Ethernet to proceed with wireless LAN configuration.
The Network Camera provides a general I/O terminal block with one digital input and one relay
switch for device control. Pin 3 and Pin 4 can be connected to an external sensor device and the
state of voltage can be monitored from the initial state 'LOW'. The relay switches Pin 1 and Pin 2
can be used to turn on or off an external device.
Consult with the dealer of the peripherals for correct installation.
The Network Camera also provides the auto iris lens connector. If the auto iris lens is used, AES
option in CCD settings must be turned OFF. And you also have to select VIDEO drive or DC
drive lens by select correct iris mode in CCD settings. The pin assignment of the auto iris lens
connector is as follows.
1 SW_COMMON OUTPUT (open from SW_OPEN at
initial state)
to ON)
2 SW_NOPEN
125VAC)
3 DI+
4 DI-
Video Drive
1. Ground, Shield
2. Not used
3. Video signal
4. Power source
(close with SW_OPEN when set DO
OUTPUT (Max. 1A, 24VDC or 0.5A,
INPUT (Max. 50mA, 12VDC)
INPUT (Initial state of DI is low)
DC Drive
1. Driver -
2. Driver +
3. Damp +
4. Damp -