Cisco AP-702W Deployment Manual page 8

AP-702W
Note
'
Table 1
702W Power
Source
Used
1. This is the power required at the PSE, which is a switch or injector.
2. In the 7.6 version code, the draw is 30 W and in the 8.0 code, the draw is now reduced to 22.1 W.
Local power supply AIR-PWR-C= may be used. Do not use AIR-PWR-B.
Note
Note
Cisco Aironet Series 702W Access Point Deployment Guide
8
At this time there is no method of disabling the "ask" for additional power if high power is
present. There is a feature request to better handle this in the future, but if the goal is to have the
AP-702W not ask for additional power, then a work around would be to configure the powering
device to only allocate 15.4 W (802.3af) power on the port that the AP-702W is attached.
PoE Requirements – if you are using PoE out on PORT 4, PoE+ or local power supply is
required
Description AP Functionality
700W - Out of the 2x2:2 (both bands) PSE
Box Powered by LAN4 port PoE @ 15.4 W
AIR-PWR-C=
(AC supply)
700W – Out of the 2x2:2 (both bands) PSE
Box Powered by LAN4 port PoE @ 7 W
ePoE or 802.3at
700W – Out of the 2x2:2 in both bands PSE
box Powered by LAN4 port no PoE.
PoE 802.3af
If PoE+ or 802.3at power source is present, the AP will negotiate higher power. If this is not
desired, a work around is to limit PoE on switch to 15.4 W until addressed in release 8.1.
If the unit is powered by 802.3at (PoE+) then the device can deliver PoE out of port 4 at 7 W
output. If 802.3af (15.4 W) is desired out of Port 4, then the local power supply AIR-PWR-C
must be used.
PoE
1
Budget 802.3af Or
(Watts) PWRINJ5 E-PoE
29.2 W NA NA
2
22.1 No Yes
15.4 Yes NA
802.3at PoE+
PWRINJ4
NA
Yes
NA