Cisco AP-702W Deployment Manual page 21

Configuring VLANs in Release 8.0
Once the LEDs are enabled, connect a client to one of the ports (1 - 4) on the 702W. The Green LED on
the 702W should be off because the ports are not yet enabled. Once the ports are enabled, the Green light
will turn on.
The GUI allows you to enable the ports and setup VLANs. In this example, VLAN 71 and 70 are enabled
on ports 1 and 2, respectively.
In the following example, VLAN is not defined on port 3 (so it will default to the native VLAN) and port
4 is disabled.
Cisco Aironet Series 702W Access Point Deployment Guide
21